Hypack User Ideas Portal
ADD A NEW IDEA

All ideas

Showing 330 of 330

Adding SSS Altitude Window in HYSWEEP Survey and more

If running sidescan with a MB you have to use HYPACK/HYSWEEP Survey. When we do this we lose a lot of the windows sidescan survey has. A very important window is the Sidescan Altitude window. We need to have atleast this window available to the us...
Caryn Zacharias over 2 years ago in Hypack 0

Send terminal commands to Mag towfish

Wilhelm van Zyl- The ability to send terminal text commands to the fish (can be from hardware setup). There is a whole list of possible commands, like calibration controls, fault finding procedures and commands returning the fish status and batter...
Joshua Sampey over 2 years ago in Hypack 0

Import historical mag data

Wilhelm van Zyl- Import historical mag data (e.g. from Sealink marine magnetics old software) or even just timeXYZ for processing)
Joshua Sampey over 2 years ago in Hypack 0

Ability to stack data in Subottom editing

Wilhelm van Zyl - To sum traces to improve the signal -to-noise ratio, reduce noise and improve seismic data quality. Traces from different shot records with a common reflection point, such as common midpoint ( CMP ) data, are stacked to form a si...
Joshua Sampey over 2 years ago in Hypack 0

Latency in Calculation in SB editor

Wilhelm van Zyl - Routine to calculate sub-bottom latency – e.g. run reciprocal lines, make a target on each line that should match, the separation should give you a latency in ms. This could also be used to calculate layback issues if the result ...
Joshua Sampey over 2 years ago in Hypack 0

Sub bottom - able to toggle the picked reflectors on and off

Wilhelm van Zyl request - This will be helpful if you are not sure of your picks, and want to see the data again. Currently the picks and lines obscure the data and you need to delete picks or the reflector to look at the data again.
Joshua Sampey over 2 years ago in Hypack 0

Have hypack revert to last sweep value in SBP

From Wilhelm Zyl - Sub-bottom driver resets to sweep of 50ms when Hypack restarts, can it revert to last know value.
Joshua Sampey over 2 years ago in Hypack 0

user requested - Multiple SBP sessions

e.g. for when you have boomer and pinger data in one project, or want to have separate sessions for different days.
Joshua Sampey over 2 years ago in Hypack 0

View GNSS quality data in MBMAx

Some users have requested a way to view GNSS quality information in hysweep, such as DOP, sat #, etc.
Joshua Sampey over 2 years ago in HYSWEEP 2 Planned

Auto updating depth filters in survey

Have the ability to allow the depth filters to auto update biased on percentage or static value above and below the average depth of the swath. If the ability to retain and use filters set in survey for processing this could be really helpfull in ...
Joshua Sampey over 2 years ago in HYSWEEP 0 Planned